Issues with Light Controller Not Running:


We recently changed our source for Micro Controllers (Arduino Nano’s) and one component that changed was the Reset Button. The new button is much larger than the originals and is prone to being pressed once the shrink wrap is installed, this is done after bench testing before shipping so the issue never manifested until in the end users hands.

If you are experiencing either a light controller that will not turn on or resets at random, please remove a portion of shrink wrap around the reset button.

Units Not affected have the following board installed:

Units that Are affected have the following board installed:

We recommend that you use a Xacto to cut away a portion of the Shrink Wrap as a fix. Cut where the red line is below if possible.

Once the shrink wrap is cut, you should see the reset button protruding as below.